Assembly

• Introduction
• Some soldering tips
• Modules soldering
• TTGO-T5 board soldering
• Speaker soldering
• Battery preparation
• Closing the case

TTGO-T5 board soldering

Before soldering the TTGO card, you must prepare it

To start, desolder the speaker

The second step will be to install the TTGO card on the PCB

Place the PCB in the bottom of the case

Place the board

Fix it with hot glue when it is well in place on its support

Solder one pin of the board, check its location and solder the opposite pin.

TFinish by soldering the other pins. Be very careful! Don’t forget some of them.

Cut the pins as close as possible to the welds

< PreviousHomeNext >